Tip #20 #20 Cold Start Finding Fish
By Capt. Jim Hirt In previous articles we covered basic leadcore. I would recommend trying a leadcore line set up. This presentation will work when all others are dead. In this article I would like to explain where to start if you have not been out for awhile. I find Internet fish reports invaluable for up to date information look for the most recent reports. If you do not have that option, ask at the local sporting goods stores or the other fisherman at the launch ramps. Marine radio is also helpful if you have one. What if none of these options are available? Then follow the steps I recommend. The tools you will need are depth gauge, temp gauge and fish locator. I key on temp and food. In most cases when you find them you will catch fish. Start with a temp check on the surface. If it is too warm for your target species, you must take a temperature check from the top to the bottom in the water you are in to see if it is cold enough for your target. East wind will bring warm water into Milwaukee. The result may be water that is too warm for your target. When you find this scenario move out to deeper water and check again. Repeat this process until you are satisfied with the temp. Look for a sharp break in temp from the warm surface to the colder water. I work tackle both slightly above and below the break. Having said that, there are exceptions to every rule. I would also run one line well above and below the temp break. This may be out of the temp you expect to catch fish, but at certain times of the day they will be there. Run your most aggressive lures with the most action on the warm side of the break. In contrast, use slower less aggressive tackle on the extreme cold side. Baitfish are a very important ingredient to this mix. Always fish schools of baitfish when you see them. When you are under power on the way out and see baitfish on the locator get the lines in. Copyright© 2006, James J. Hirt, All Rights Reserved.